I installed the LED Indicator light lens for the Annunciator sound board into the Upper Console. Drilled a hole and then filed it to fit the lens. I cut out a hole for the microphone and snipped out a small piece of speaker grill I had kicking about. I glassed the grill over the microphone hole to secure it in really well.
The next step will be to mount in that small piece of circuit board with the microphone and indicator LED attached to it over where the LED lens and microphone hole is located. Once that's done I just need to loom the wires up nice and secure. I still need to determine a good place under the hood to install the Annunciator loudspeaker as I know I'm more than likely going to need to lengthen it's wires, seems they never give you enough length of wire on any of that stuff... lol then again I guess they never figure someone is going to be installing it in such a way as I am here. ;)
I think I have worked out a wiring scheme for the Voice Projection Unit Power Button. This is pretty much following along the same as the dashboard's Power Button, it should pretty much work in the same way. I figure what I'll do is pull out my Voice Projection Unit Power Button that is currently mounted in under the OEM plastic dash in the car. I'll set it up in the back room along with the dash and see if it works along with the dash powered up. My intention is to have the Voice Projection circuit only active when the Voice Projection button is powered to ON. If it is OFF then the Switch Pod Buttons should ONLY produce their DTMF Tones played out through the Voice Box. That's the plan, as near as I can tell from looking at my wiring schemes this is how it should work. I'll keep you posted. Right now I'm in the process of getting all the parts to the Annunciator sound board into the Upper Console.
